Himalayas: next major quake may be west of the recent one

Stress loading could have occurred further west of the main quake’s focus.

April 30, 2015 12:50 am | Updated November 17, 2021 02:12 am IST

Since the soil at Kathmandu valley is soft and “liquefies easily”, the seismicwaves get amplified, thereby amplifying the ground motion.

Since the soil at Kathmandu valley is soft and “liquefies easily”, the seismicwaves get amplified, thereby amplifying the ground motion.

“In future, if any earthquake were to happen along the Himalayas, it may happen further west of the focus of the main April 25 quake,” said Dr. R.K. Chadha, Chief Scientist at the Hyderabad-based National Geophysical Research Institute.

That is because the 7.8 magnitude April 25 quake was caused by a unidirectional fracture. From the focus of the earthquake, the fault propagated in a nearly west to east direction thereby releasing the energy that was stored for many decades.

While stress unloading has taken place from nearly west to east of the focus of the main quake, stress loading could have occurred further west of the focus of the main quake.

A case in point The December 24, 2004 Sumatra earthquake that caused the killer tsunami waves was also caused by a unidirectional fracture that propagated in a south to north direction. As a result of the unidirectional fault propagation, stress was unloaded in the northern direction and stress loading occurred south of the focus of the main Sumatra earthquake. “This caused the March 28, 2005 earthquake of 8.7 magnitude in the Nias Island, some 300 km south of Sumatra,” he said.

Thrust faulting The April 25, 2015 quake was caused by thrust faulting “on or near the main frontal thrust” where the Indian plate is pushed under the Eurasian plate. According to the U.S. Geological Survey, from the epicentre of the earthquake, nearly 80 km to the northwest of the Nepalese capital of Kathmandu, the India plate is converging with the Eurasian plate at a rate of 4.5-5 cm per year.

About 3 cm of the Indian plate movement is accommodated in the Himalayan collision zone and the remaining is accommodated along the east-west strike-slip faults in the Tibet region. As a result, earthquakes caused by thrust fault in the Himalayan region occur along the strike-slip fault in an east-west direction.

Any quake will cause displacement either in a vertical or horizontal direction. “We don’t know for sure the amount of displacement caused by this earthquake,” said Dr. Chadha, “but for an earthquake of 7.8 magnitude [revised value], the displacement can be 1 to 2 metres along the fault. The quake was on a thrust fault and so most of the displacement will be in a vertical direction.”

According to Colin Stark at the Lamont-Doherty Earth Observatory, Columbia, 1-10 feet of India had slipped northward underneath Nepal.

The U.S. Geological Survey has revised the depth of the focus to around 15 km. Explaining why the focus of the earthquake cannot be a couple of kilometres deep as initially put out, he said the magnitude of an earthquake has a relationship with the volume of crust. Hence, the focus of the quake has to be 10-15 km deep as a large volume of crust is needed for a 7.8 magnitude quake.

Amplification of waves Nepal is situated on an ancient lakebed and hence the soil at Kathmandu valley is soft and “liquefies easily.” Unlike a rocky terrain where the seismic waves travelling with great velocity can have very good transmission, a terrain with sediments can amplify the seismic waves, thereby amplifying the ground motion.

A continental-continental plate collision will necessarily produce shallow-focus earthquakes (less than 70 km) as continental plates are less dense than oceanic plates and both the plates have the same density. However, when two ocean plates collide, both the plates will go down to form a trench, like in the case of the Mariana Trench in the Pacific Ocean.

“Both the ocean plates will go down because of the role of gravity,” Dr. Chadha said. In the case of two colliding continental plates, gravity is not that intense.

In the case of a continental plate colliding with an oceanic plate, the oceanic plate subducts under the continental plate as it is heavier than the continental plate. In general, the focus of most of the earthquakes in subduction zones is intermediate (70-300 km) to deep (300-600 km).

Rain stalls rescue work in Nepal

>

Toll could reach 10,000, says Nepal Prime Minister

With no electricity, Kathmandu looked a ghost town with rain pounding the city..

>

A selection of images capturing the extent of damage

These visualisations show how the intensity varied with distance from epicentre. > Read more The PM spoke to Nepal President and Chief Ministers of Bihar, Sikkim. > Read more Helpline no.s: +91 11 2301 2113, +91 11 2301 4104 and +91 11 2301 7905. > Read more
"Blind thrust" quakes are ones that do not break the surface, and tend to be more frequent. These records indicate that the region has a rich history of quakes in the past centuries. > Read more
 
A magnitude-7.8 earthquake shook Nepal’s capital and the densely populated Kathmandu Valley on Saturday, the worst quake in the Himalayan nation in over 80 years. A look at the world’s strongest earthquakes since 1900. > Read more
  

Top News Today

Sign in to unlock member-only benefits!
  • Access 10 free stories every month
  • Save stories to read later
  • Access to comment on every story
  • Sign-up/manage your newsletter subscriptions with a single click
  • Get notified by email for early access to discounts & offers on our products
Sign in

Comments

Comments have to be in English, and in full sentences. They cannot be abusive or personal. Please abide by our community guidelines for posting your comments.

We have migrated to a new commenting platform. If you are already a registered user of The Hindu and logged in, you may continue to engage with our articles. If you do not have an account please register and login to post comments. Users can access their older comments by logging into their accounts on Vuukle.