Features » Property Plus

Updated: September 20, 2013 15:56 IST

From base to roof

sathyaprakash varanashi
Comment   ·   print   ·   T  T  
The traditional bamboo walls were made with woven bamboo mat with mortar coats on both sides, so that bamboo is not exposed to any adverse weather condition.
Special Arrangement
The traditional bamboo walls were made with woven bamboo mat with mortar coats on both sides, so that bamboo is not exposed to any adverse weather condition.

There are many valid reasons to use bamboo in construction

Between bamboo and structural steel, which one is stronger? Which one will perform better in case of a deep soil pile foundation? If left open without a protective coat, which will last longer? Which material is versatile enough for walls, columns, beams and floors?

The answer is bamboo. At an average tensile strength of 12,500 kg/sq. inch, it is 2,000 kg units more than that of steel. The stems of bamboo, popularly called poles and technically as culms, have been traditionally used for pile foundation in water-logged and loose top soil sites. Bamboo mats can be laid as foundation bed in case of soils with low load-bearing capacity. As a versatile material, it is good for both temporary and medium term usages, besides for long term, if designed and built properly.

While bamboo can be used as a single pole, it works equally well in groups and as a composite material. For transferring heavy loads, multiple numbers of culms, say 3 or 4, can be joined by nuts and bolts to act like a single column. Likewise, it is possible to form beam trusses in groups or in lattice formation. Of course, all the bamboo poles in such composite forms need to belong to the same species, of similar girth and be of comparable maturity of age.

In Kerala, lime concrete bamboo reinforced beams have been attempted since the late 1990s and in regular use since then at the Laurie Baker Centre. While stand alone use is feasible, bamboo gains more potential as part of a composite structure and reinforcement material.

Traditional walls

Traditional bamboo walls were made with woven bamboo mat and mortar coats on either sides, so that the bamboo is not exposed to any adverse weather. While lime and mud mortar goes better with the natural material, cement mortar can also be used. Subsequently, protective painting coats can be applied. Being 2 to 3 inch thick, they are light-weight, hence save on structures. If split bamboo culms are used, keep them to the outside with inside finished as desired. External silica-based skin of bamboo resists fire for a while, but can be improved by chemical coatings. Bamboo boards with split lengths and panel are very popular as visual barrier in semi-open spaces like verandahs and pavilions.

Roof supports by bamboo rafters are very commonly found even today. Thicker girth culms are used as ridge beams or wall beams, while the smaller diameter ones can go for principal rafters in sloping and cross beams in flat roofs. Their spacing may vary from 1 to 2 metres depending on context. Floor finish can be achieved by 1:6 ratio lime mud or cement mortar with topping by floor tiles and any other item of choice.

The writer is an architect working for eco-friendly designs and can be contacted at

This article is closed for comments.
Please Email the Editor



Recent Article in Property Plus

Creating an energy-efficient model

Hunt is on for an ideal place for developing an energy-efficient panchayat as a model for the State, reports K. A. Martin »